Diy Gutter Planter

This will lock each segment along the suspension wire.
Diy gutter planter. The front and back of each gutter piece will have 2 holes. For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment. Then thread the brace piece through the same clamp and tighten it with a screwdriver. Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
Tie a knot at one end of the 10 foot rope. Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter. Measure 12 inches of. 10 ft vinyl gutter but i only used about 6 feet of it 3 sets vinyl gutter end caps 1 4 inch natural fiber rope it comes in 50 feet rolls which is plenty home depot pdf instructions.
Garden answer youtube.